Enrolling 5800 Transmitters Into The System; Enrolling Through Zone Programming ( 56) - ADEMCO VIA-30Pse Installation Instructions Manual

Enrolling 5800 Transmitters Into The System

There are two methods that may be used to enroll transmitters. The first method is performed
in 56 zone programming mode (which is contained in this section) and describes how to enroll
each transmitter into the system as you are entering the zone information.
The second method is called "sequential mode" and uses 83 (described in the SEQUENTIAL
MODE section later in this manual. This section describes how to enroll all the transmitters into
the system after all zone information has been entered .
As an option, the zone programming and sequential modes allow you to use a 5803 or 5804
button-type transmitter as a "program tool." The advantage of using a program tool is that it
tells the control that you are about to enroll a transmitter into the system. You can move to the
physical location of the transmitter to be enrolled, press the upper left-hand button of the
program tool, and then trip the intended transmitter (see step 10 for operation). This helps to
prevent random signals from being accepted into the system until you are ready to enroll the
intended transmitter.
The transmitter that you use as the program tool can also be used as a transmitter in the
system. If you plan to use an existing transmitter, it must first be enrolled into the system as its
associated zones. You may then program it as the tool.

Enrolling Through Zone Programming ( 56)

Program Tool?
0 = No, 1 = Yes 0
00 Input S/N: L
A
X X X–X X X X
00 Input S/N: L
A123-4567 3
En te r Zn Nu m .
( 0 0 = Q u it) 1 0
Zone 10 entered ↑
ZN ZT – RC I n : L
1 0 0 0 – 0 0 RF : 1
1. Enter Programming mode [Installer Code] + 8 + 0.
Enter Zone Programming by pressing 56. If the system has been set
up to use 5800 series RF, and a program tool has been entered, skip
to step 4. If no program tool has been entered, the following prompt
will appear:
2. If a program tool is being used, enter "1." If not using a tool, enter "0"
and skip to Step 4.
3. If "1" is entered, the system will prompt for the unit's serial number.
Enter the program tool's serial number using one of the following
methods:
a) Enter the 7-digit serial number for the transmitter
or
b) Press any button on the transmitter. The keypad should beep twice
and display the serial number of the tool.
In this example, the serial number is A123-4567. Once enrolled, the
upper left-hand button of the program tool can be pressed to ready the
system for enrolling a transmitter into the system.
Pressing the [#] key on the keypad will cause the system to back up to
the "Program Tool ?" prompt.
The serial number for the program tool will only remain in the
system until the programming mode is exited. (Entering
not delete the tool.)
Press [ ] to continue.
4. Enter the zone number that you wish to program. As an example, zone
10 is shown here.
Press [ ] to continue.
5. A display will appear, showing a summary of that zone's programming.
If the zone is not programmed, the display will appear as shown here. If
checking a zone's programming, and it is programmed satisfactorily,
press [#] to back up one step and enter another zone number, if
desired. Otherwise, press [ ] to continue.
6 –13
97 will