ADEMCO VIA-30Pse Installation Instructions Manual page 73

En te r Zn Nu m .
( 0 0 = Q u it) 1 5
7. The system will search for the next zone that does not have a serial
number associated with it. If one is found, the prompt in step 5, along
with the appropriate zone number, will be displayed. Follow steps 5
and 6 for the remaining wireless zones.
If you are enrolling transmitters which have already been physically
installed, move to the location of the transmitter to be enrolled before
pressing the upper left-hand button of the program tool. Press the button
and then immediately activate the transmitter to be enrolled. This will
minimize the possibility of the system accepting a random transmission
instead of one from the intended transmitter.
8. After all wireless zones have been displayed, whether enrolled or not,
the "Enter Zn Num." prompt will appear.
Enter "00" to exit the Sequential mode and return to the data field
programming mode.
When you have finished programming all zones, test each using the
system's TEST mode (see TESTING THE SYSTEM section).
Do not use the Transmitter ID Sniffer mode for testing, as it will only
check for transmission of one zone on a particular transmitter, and
NOT the zones assigned to each additional loop.
14 –3