ADEMCO VIA-30Pse Installation Instructions Manual page 10

Paging Feature
If the paging feature has been programmed for your system, your pager will
respond to certain conditions as they occur in your system, and display code
numbers indicating the type of condition that has occurred.
Quick Arm Feature
"Quick Arm" may be programmed , allowing use of the [#] key in place of the
security code for arming (Quick Arm will not work unless the Master code has
been programmed into the system).
Optional Output Relays
Supports up to 4 relays using one 4204 Relay Module, or 2 relays using one
4229 Zone Expansion/Relay Module.
• Actions programmable to respond to zone activity or manual keypad
entries.
Optional Phone module
Supports the Ademco 4285 VIP Phone Module.
• Provides access to the system via on premises or off-premises phones for
arming, disarming, etc., plus control of relay outputs.
Optional Long Range Radio
• Allows all messages that have been programmed to go to the primary
telephone number to be reported additionally to a 7720 PLUS or 7820
radio.
Alarm Output
Provides a 12VDC, 2 AMP output that can drive the compatible sounders listed
in the EXTERNAL SOUNDERS section (
connected)
• Steady output for Burglary/Panic, or t emporal pulse sounding output for
Fire notification, as required by UL.
• Uses current limiting circuitry for protection.
Auxiliary Power Output
Provides 12VDC, 500mA maximum. Uses current limiting circuitry for
protection.
• Output interrupts for smoke detector reset if 4-wire smoke detectors are
used.
Programming
• Programmed options are stored in electrically erasable, non-volatile
EEROM memory (information can be reprogrammed at any time and will
not be lost in the event of a power loss).
• The system can be uploaded, downloaded, or controlled via an IBM
compatible computer, using either Ademco's V-Link downloading software
(Rev. 4 or higher) or Ademco's Compass Windows downloading software,
and a modem specified by Ademco.
Keypad programming consists of:
• Data field programming.
• Interactive (menu) mode programming.
For programming from a keypad, a 5137AD or 6139 2-line Alpha keypad must
be connected (but need not necessarily stay in the system).
Communication Formats Supported
• Ademco Low Speed (Standard or Expanded).
• Sescoa/Radionics (Standard or Expanded).
• Ademco Express.
• Ademco Contact ID.
Zone Descriptors
You can assign Alpha descriptors to all zones (useful only when using Alpha
keypads and/or the 4285 Phone module).
.
1 –2
assumes a fully charged battery is