Advanced Functions; Chime Feature; Omitting Inputs; Keypad Hold Up - Pyronix Enforcer 32-W User Manual

1 2 . A d v a n c e d F u n c t i o n s

12.1 Chime Feature

The chime can be used for any input on
the system. This can be set up by your
engineer.
To enable the chime on the keypad,
when the time is displayed, press c .
'c' will be displayed on the right side of
the keypad display. Press c again to
clear the chime feature.

12.2 Omitting Inputs

On occasion, a detector may need to be
isolated if a room is occupied.
Enter your user code
Press I .
Select the inputs that need to be omitted
Press A .
After 10 seconds the exit time continues.
NOTE: Inputs have to be programmed
as 'omittable' by your Engineer for this
feature to operate.

12.3 Keypad Hold Up

If an emergency alarm is needed, press
and hold both 1 and 7 .
A 'hold up' alarm will be generated.
NOTE 1: The Hold Up facility needs to
be enabled by your engineer (either
silent or full alarm)
2-Key HU and any duress codes
programmed on the system by your
engineer are not permitted to send a
signal to the Alarm Receiving Centre
under police regulations in England,
Wales or Northern Ireland
NOTE 2: The keyfob can also be
programmed to support a hold up alarm.
Please discuss this with your Engineer.
User Manual
Page: 15