Unable To Arm; Control Panel Indication; Keyfob Indication; Advanced Functions - Pyronix ENFORCER V11 Extended User Manual

If 'unable to set' is displayed, it indicates that a zone is open
and the area where the zone is should be checked for open
windows, pets, movement etc.
If the problem cannot be solved contact your engineer, or
bypass the zone.
If the panel is unable to arm for any reason, the keyfob status LED flashes amber indicating a fault is on the system.
The chime can be used for any zone on the system. This can be
programmed by your engineer.
To enable the chime on the keypad, when the time is displayed,
press c.
'c' will be displayed on the right side of the keypad display. Press
c again to clear the chime feature.
On occasion, a detector may need to be isolated if a room is
occupied.
Enter your User Code.
Press f.
Select the zones that need to be bypassed'
Press h.
After 10 seconds the exit time continues.
Please note: Zones have to be programmed as bypassable by your engineer for this feature to operate.
A 'hold up' alarm will be generated when 1 and 7 are
pressed and held down for 2 seconds (this time period can be
altered by your engineer).
Please note 1: The keyfob can also be programmed to provoke a hold up alarm. All hold up alarms including
duress codes must be enabled by the engineer.
Please note 2: This feature is not available from the tablet application.
ENFORCER V11 EXTENDED USER GUIDE

UNABLE TO ARM

Control Panel Indication

Unable To Set
Input 01

Keyfob Indication

ADVANCED FUNCTIONS

Alarm Panel
Time 10:09 c

OMITTING ZONES

Select Omit [01]
Input 01

KEYPAD HOLD UP

Alarm Silenced
2 Key HU

CHIME

13