Fully Utilizing Cutting Function; Hints And Tips For Cutting Setting; Preventing Pulling Of The Media With Undue Force When Performing Cutting Only - Roland LEC-540 User Manual

Fully Utilizing Cutting Function

Hints and Tips for Cutting Setting

 Setting the [PREFEED] menu item to "ENABLE" makes the machine automatically feed out
media and take it up again before cutting. This makes it unnecessary to run out media to the
rear of the machine before the operation.
 P. 133, "Preventing Pulling of the Media with Undue Force When Performing Cutting Only"
 The tip of the blade holder cap may scrape, and soil or damage the printed surface. If this
happens, increase the amount of blade extension.
 P. 136, "Accurately Adjusting the Cutting-in Amount"

Preventing Pulling of the Media with Undue Force When Performing Cutting Only

Procedure


MENU
CUTTING MENU

CUTTING MENU
PREFEED

PREFEED
DISABLE ENABLE

W 736 mm
SETUP SHEET
ROLL
Description
This feeds out media according to the size of the data sent from the computer before performing cutting.
Therefore, the media does not have to be hanged down manually before every cutting operation.
Note, however, that this feeds out media even when you're performing printing only, so set it to "DISABLE"
when not needed
Default Setting
[PREFEED]: DISABLE
Press to display the left figure.
Press .
Press to display the left figure.
Press .
Press to select "ENABLE."
Press to enable the setting.
Press
original screen.
in this order to go back to the
5
133