Jcu Ii Power Menu; Standby States - FLIR M400 Operator's Manual

JCU II Power Menu

JCU II Power Menu
The JCU II LCD screen generally shows the ID of the camera that is connected to the JCU II. The
various functions are accessed from a set of menus, with each menu entry selectable in the JCU II
display. When powered on and connected to a camera, pressing and holding the Power button
causes the JCU II to enter the Power Menu.
Use the JCU II joystick to scroll up and down within the menus
(push fore and aft), and select an entry by clicking the left
joystick button. When the JCU II is in the Power Menu mode,
the other JCU II buttons are disabled.
In the JCU II display, a down arrow (v) indicates you can access
additional menu choices by moving the joystick down. An up
arrow (^) indicates the last menu entry is displayed, and the
other choices must be accessed by moving the joystick up. A
double arrow indicates you can move up or down in the menu.
The Power Menu shows the following menu options:
Assign JCU?
JCU Stndby?
Camera Stndby?
System Stndby?
Global Stndby?
Calibrate JCU?
Cancel

Standby States

After you are done with the camera you can Park the camera from the OSD menu keeping the
system ready to use at a moments notice on a command from the JCU II. When the system is in
Park mode, the camera does not generate a live video signal.
To initiate other standby modes, press and hold the Power button. After a brief countdown, the
Power Menu is shown. Scroll down with the joystick, press the left joystick button to select an
option from the menu. The menu options available will reflect the available hardware on the
camera network.
• JCU Stndby?—select to power down the JCU II.
• Camera Stndby?—select to power down the camera, leaving the JCU II powered
to connect to a different camera.
• System Stndby?—select to power down the camera and the JCU II.
• Global Stndby?—select to power down all the cameras and all the JCU IIs present on the
network.
Troubleshooting Tip: If the JCU II does not have power, it may be connected to a Power over
Ethernet (PoE) switch that has not been powered on, or it may be connected to a network switch
that does not provide PoE power.
Troubleshooting Tip: If this is the first time the JCU II has been used to connect to the camera, or
if the camera was not powered before the JCU II, v Select Camera is shown on the LCD
screen. Scroll down with the joystick to select a camera to control. When the ID of the camera
appears, press the left joystick button to select it. The camera ID will blink momentarily to indicate
it has been selected.
432-0012-00-10 Version 100 December 2015 15