DAELIM S2 125 Service Manual page 71

LH. CRANKCASE COVER/CONTINUOUSLY VARIABLE TRANSMISSION
DRIVEN
PULLEY ASS'Y
DRIVE BELT
LOCK NUT WRENCH
LOCK NUT
CLUTCH SPRING COMPRESSOR
DRIVEN FACE SPRING
SPRING GUIDE
7-8
UNIVERSAL
HOLDER
DRIVE PLATE
CLUTCH/DRIVEN PULLEY
REMOVAL
● Remove the LH. crankcase cover. (
● Remove the drive face. (
● Hold the clutch outer using the universal holder and
remove the flange nut, then remove the clutch outer.
TOOLS : UNIVERSAL HOLDER
DRIVE FACE HOLDER
● Remove the driven pulley sub assembly from the drive
shaft.
● Remove the drive belt.
DISASSEMBLY
● Install a clutch spring compressor on the pulley
assembly and tighten the tool to gain access to the nut.
·Do not overtighten the compressor.
● Hold the clutch spring compressor in a vise as shown
and remove the lock nut using the lock nut wrench.
● Loosen the clutch spring compressor and disassembly
the clutch and spring from the driven pulley.
TOOLS : CLUTCH SPRING COMPRESSOR
LOCK NUT WRENCH
● Remove the drive plate, driven face spring and driven
face spring guide.
7-2)
) X h
@ ) X ? g
@ V / X g @ ? V / X ? f
@ @ @ @ @ @ @ @ @ @ @ ? ? V / X f
@ ? h f V / X ? e
@ ? h f ? V / X e
@ ? @ ? J 5 e N 1 e
@ ? h f ? W . Y e
@ @ @ @ @ @ @ @ @ @ @ ? e W . Y ? e
@ ? ? W . Y f @ ? W . Y ? f
@ W . Y g
@ ( Y ? g
( Y h
7-5)
) X h
@ ) X ? g
@ V / X g
@ ? V / X ? f
@ ? h f V / X ? e @ @ @ @ @ @ @ @ @ @ @ ? ? V / X f
@ ? h f ? V / X e
@ ? N 1 e
@ ? @ ? h f ? W . Y e J 5 e
@ @ @ @ @ @ @ @ @ @ @ ? e W . Y ? e
@ ? ? W . Y f
@ ? W . Y ? f
@ W . Y g @ ( Y ? g
( Y h