Front Wheel - DAELIM S2 125 Service Manual

FRONT WHEEL/FRONT FORK/STEERING/BRAKE
BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER
BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER
BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER
BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER BRAKE MASTER CYLINDER
12-4
AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT AXLE NUT
DIAL GAUGE
AXLE
● Lubricate the throttle grip front end with grease and
then install the throttle grip.
●
Connect the throttle cable to the throttle grip.
● Install the right and left handlebar switches and tighten
the screws.
·Adjust the throttle grip free play to the specified
range of 2~6mm.
● Install the front and rear brake master cylinders.
·Install the brake master cylinders by aligning the
index marks.
● Install in the reverse order of removal.

FRONT WHEEL

REMOVAL
● Jack the motorcycle front wheel off the ground.
● Remove the front axle nut to pull out the axle.
● Remove the front wheel and the speedometer gear unit.
INSPECTION
AXLE RUNOUT
● Set the axle in V blocks and measure the runout using a
dial gauge.
● The actual runout is 1/2 of the total indicator reading.
SERVICE LIMIT : 0.2mm replace if over