DAELIM S2 125 Service Manual page 45

LUBRICATION SYSTEM
PUMP PLATE
PUMP BODY
OUTER ROTOR
OUTER ROTOR
PAN SCREW
FLAT SCREW
4-6
INNER ROTOR
PUMP SHAFT
ROLLER2.5x11.8
INNER ROTOR
PUMP PLATE
OIL PUMP ASSEMBLY
●Clean all parts with fresh cleaning oil.
●Install the inner and outer rotors to the pump body.
●Assemble the pump shaft with setting pin.
●Install the oil pump plate to the pump body.
●Tighten the pan screw.
•After installing, check the oil pump to operate
smoothly.
OIL PUMP INSTALLATION
●Install the oil pump to the RH. crankcase.
●Install the following parts.
-Oil pump drive gear and driven gear.
-Starting clutch assembly. (⇨8-8)
-Starter driven gear and reduction gear (⇨8-5, 8-7)
-A.C. generator (⇨8-2)
-RH. crank case cover (⇨8-4)
-Shroud and cooling fan (⇨8-2)
-Rear swing arm (⇨13-7)
-Rear caliper (⇨13-3)
-Muffler (⇨3-8)