DAELIM S2 125 Service Manual page 64

7. LH. CRANKCASE COVER
/CONTINUOUSLY VARIABLE TRANSMISSION
SERVICE INFORMATION· · · · · · 7-1
TROUBLESHOOTING· · · · · · · · 7-1
LH. CRANKCASE COVER · · · · 7-2
SERVICE INFORMATION
GENERAL SAFETY
● Do not allow oil to contact the drive belt or the pulley face. The transmission rate of driving force is reduced with oil
contact.
● Do not operate starter motor while the LH. crank case cover is removed.
·Take precautions not to apply the grease oil to the movable drive face or weight roller.
SPECIFICATIONS
ITEM
MOVABLE DRIVE FACE BUSHING INNER DIAMETER
DRIVE FACE BOSS OUTER DIAMETER
DRIVE BELT WIDTH
WEIGHT ROLLER OUTER DIAMETER
CLUTCH OUTER INNER DIAMETER
DRIVEN FACE SPRING PLAY
DRIVEN FACE OUTER DIAMETER
DRIVEN FACE INNER DIAMETER
TROUBLESHOOTING
Engine starts but motorcycle does not work.
● Drive belt worn.
● Ramp plate damaged.
● Clutch shoe worn or damaged.
● Movable driven face spring cut.
Engine stops, or the vehicle runs suddenly,
after starting.
● Clutch shoe spring cut.
DRIVE BELT· · · · · · · · · · · · · · · · · · 7-6
MOVABLE DRIVE FACE· · · · · · 7-8
CLUTCH/DRIVEN PULLEY· · · · 7-11
STANDARD
24.000-24.013mm
23.980-23.993mm
22mm
19.95-20.02mm
120.0-120.2mm
97.85mm
37.965-37.985mm
38.000-38.025mm
Vehicle unable to run at the maximum speed,
or lack of output
● Drive belt worn.
● Defective movable driven face spring.
● Weight roller worn.
● Pulley face contaminated.
SERVICE LIMIT
24.05mm
23.96mm
20.50mm
19.50mm
120.50mm
90.00mm
37.94mm
38.06mm
7-1
7