Front Wheel Installation; Brake Master Cylinder - DAELIM S2 125 Service Manual

SPEEDOMETER GEAR BOX
SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX
SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX
SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX
SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX SPEEDOMETER GEAR BOX
FRONT WHEEL/FRONT FORK/STEERING
FRONT AXLE
FRONT AXLE FRONT AXLE FRONT AXLE FRONT AXLE FRONT AXLE FRONT AXLE
FRONT AXLE FRONT AXLE FRONT AXLE FRONT AXLE
FRONT AXLE FRONT AXLE FRONT AXLE FRONT AXLE
FRONT AXLE FRONT AXLE FRONT AXLE
AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT AXLE NUT AXLE NUT
AXLE NUT AXLE NUT AXLE NUT AXLE NUT
AXLE NUT
● Apply grease to the dust seal rim.
● Install the dust seal, and align the tangs of the
speedometer gear retainer with the gear groove to
assemble the speedometer gear box.

FRONT WHEEL INSTALLATION

● Insert the front wheel between the front forks.
● Insert the disk, taking precautions not to damage the
pad, and assemble the wheel.
● Align the slots of the speedometer gear with the tangs
of the left fork slider.
● Insert the front axle into the speedometer gear box and
the wheel hub.
● Install the axle nut.
● Install the speedometer cable, and tighten with screws.
● Place the front wheel on the ground, and tighten the
axle nut to the specified torque.
TORQUE VALUE : 5.0-7.0 kgf·m
FRONT WHEEL

BRAKE MASTER CYLINDER

REMOVAL
● Remove the handlebar covers.
● First drain the brake fluid from the hydraulic brake
system.
● Disconnect the front stop switch wire connector.
● Remove the brake fluid tube bolt.
● Remove the two bolts securing the brake master
cylinder.
● Remove the brake master cylinder.
12-7