DAELIM S2 125 Service Manual page 171

STARTER SYSTEM
TROUBLESHOOTING
Starter motor will not turn.
● Check for a blown main fuse before servicing.
● Check that the stop light is correctly adjusted.
● Check that the side stand is positioned in the condition under which the engine can be started.
With the ignition switch "ON"and squeeze
the brake lever, check for a " click" sound
from starter magnetic switch. (⇨16-6)
NO CLICK.
Disconnect starter magnetic switch coupler,
and check the starter magnetic switch coil
ground wire. (⇨17-7)
CONTINUITY.
Connect the starter magnetic switch coupler.
Measure the starter magnetic voltage at the
starter magnetic switch coupler. (⇨16-6)
VOLTAGE MEASURED.
Check the starter magnetic switch operation.
(⇨17-8)
Starter motor turns slowly.
● Low specific gravity in battery. (or dead battery)
● Poorly connected battery terminal cable.
● Poorly connected starter motor cable.
● Faulty starter motor.
● Poorly connected battery ground cable.
● Damaged or worn brush.
Starter motor and engine turns, but engine does not start.
● Faulty ignition system.
● Engine problems.
Starter motor turns, but engine does not turn over.
● Starter motor is running backwards.
-Brushes assembled improperly.
-Case assembled improperly.
-Terminals connected improperly.
● Faulty starter clutch.
● Damaged starter gear.
16-2
NO CONTINUITY.
ABNORMAL
CLICKS
Starter motor turns.
● Loose or disconnected
● Faulty starter switch.
● Faulty side stand switch.
● Loose or poor contact at connector.
● Open circuit in wire harness.
● Faulty ignition switch or starter switch.
NO VOLTAGE.
● Loose or poor contact at connector.
● Open circuit in wire harness.
● Faulty brake stop switch.
NORMAL
● Loose or poor contact at starter magnetic
● Faulty starter magnetic switch.
Connect the starter motor (+) terminal to the
battery positive terminal. (Because a large
amount of current flows, do not use thin
wires). (⇨16-3)
Starter motor does not turn.
● Faulty starter motor.
wire or cable.
switch coupler.