Oil Pump - DAELIM S2 125 Service Manual

LUBRICATION SYSTEM
ELEMENT
DRIVE
GEAR
NUT
FLAT SCREW
4-4
OIL FILTER COVER
OIL FILTER SEAL
DRIVEN GEAR
OIL FILTER ELEMENT CHANGE
●Drain engine oil. (⇨4-3)
●Loosen the 3 flange bolts securing the oil filter cover,
remove the oil filter cover.
●Remove the oil filter element and oil filter spring.
●Change the oil filter element with a new one.
●Check if the oil filter seal is in good condition.
●Assemble the filter element spring and filter cover, and
tighten bolts.
TORQUE VALUE : OIL FILTER COVER 1.1kgf·m
•Always use a genuine oil filter element.
•Be sure to replace the oil filter seal when removing oil
filter element.
•Be careful not to lose the oil filter spring when
assembling the oil filter element.

OIL PUMP

REMOVAL
●Remove the following parts :
-Rear cushion lower bolt (⇨13-7)
-Muffler (⇨3-8)
-Rear swing arm (⇨13-7)
-Rear caliper (⇨13-3)
-Shroud (⇨8-2)
-Cooling fan (⇨8-2)
-A.C. generator (⇨8-2)
-RH. crankcase cover (⇨8-4)
-Starter driven gear (⇨8-7)
-Reduction gear (⇨8-5)
-Starting clutch assembly (⇨8-8)
●Loosen the oil pump driven gear setting nut.
●Remove the oil pump driven gear.
●Remove the oil pump drive gear.
●Loosen the 3 flat screws securing the oil pump.
●Remove the oil pump.