Front Wheel Bearing - DAELIM S2 125 Service Manual

FRONT WHEEL/FRONT FORK/STEERING/BRAKE
DIAL GAUGE DIAL GAUGE DIAL GAUGE
DIAL GAUGE DIAL GAUGE DIAL GAUGE DIAL GAUGE
DIAL GAUGE DIAL GAUGE DIAL GAUGE DIAL GAUGE
DIAL GAUGE DIAL GAUGE DIAL GAUGE DIAL GAUGE DIAL GAUGE DIAL GAUGE
DIAL GAUGE
BEARING
WHEEL RIM
● Check the wheel rim runout.
SERVICE LIMIT :
RADIAL : 2.0mm replace if over
AXIAL : 2.0mm replace if over

FRONT WHEEL BEARING

INSPECTION
● Turn the inner race of each bearing with your finger to
see if they turn smoothly and quietly Also check if the
outer race fits tightly in the hub.
● Replace the bearings if the races do not turn smoothly,
quietly, or if they fit loosely in the hub.
WHEEL BEARING REPLACEMENT
● Install the bearing remover head and the remover shaft
on the wheel, and remove the bearing and distance
collar.
·Always replace bearings in pairs, and never use old
bearings.
TOOLS : BEARING REMOVER HEAD
BEARING REMOVER
● Apply sufficient amount of grease to the bearing.
● Insert the right bearing with its seal surface facing
outside.
● Do not tilt the bearing. Insert accurately.
● Upon assembling the distance collar, insert the left
bearing with its seal surface facing outside.
TOOLS : DRIVER HANDLE A
DRIVER PILOT
OUTER DRIVER
·The bearing inserted in the last must be inserted until
it contacts with the distance collar.
·Excessively inserted bearing can cause damage the
opposite side bearing.
12-5