Lcd Hinge Assembly, Pr-037, Po-007 Boards - Sony DCR-PC6E Service Manual

2-11.LCD HINGE ASSEMBLY, PR-037, PO-007 BOARDS

(Remove the LCD unit referring to section 2-1 before starting disassembling.)
3 Blind plate assembly,
PO-007 board
1 Screw
(M1.7 × 2.5)
2 Tapping
screw
(M1.7 × 5)
2 PD-113 harness
SOLDERING OF HARNESS (PR-063)
Soldering position
PO-007 board
PR-037 board
Harness
(black)
Harness
(gray)
A PR-063 harness
4 Screw (M1.7 × 2.5)
9
4 LCD hinge assembly
1 PR-063 harness
3 PR-037 board
PR-037 board
Harness
(black)
Harness
(gray)
Harness
PO-007 board
(black)
Harness
Harness
(gray)
(black)
6 Hinge cover (rear)
5 Two claws
7 Claw
8 Hinge cover (front)
6 PO-007 board
5 Two solderings
1 Connect the black harness at the leftmost end of the
harness (PR-063) and connect the second gray harness
(PR-063) to the PR-037 board by soldering.
Boss hole
2 Check that there is no cold soldering, non-soldering,
solder slump nor solder bridge.
Harness
Note: Align the direction of the harness A as shown in the
(gray)
picture.
Be careful that the harness must not be caught by the
boss hole.
3 Connect the third black harness and the fourth gray harness
from the leftmost end of the PO-007 board by soldering.
4 Check that there is no cold soldering, non-soldering, solder
slump nor solder bridge.
Note: Align the direction of the harness A as shown in the
picture.
Boss hole
Be careful that the harness must not be caught by the
boss hole.
Specification
Reference of counting the harness starts counting from the
black harness in the end.
2-9
4 Blind plate
3 Two claws
assembly
2 PR-037 board
1 Two solderings
7 PR-063 harness