Sony DCR-PC6E Service Manual page 74

[SERVICE POSITION TO CHECK THE CAMERA SECTION]
Connection to Check the Camera Section
To check the camera section, set the camera to the "Forced camera power ON" mode. (Or, connect the control switch block
(PS-1770) to the control switch block (FK-1770) and set the power switch to the "CAMERA" position.)
Operate the camera functions of the zoom and focus using the adjustment remote commander (with the HOLD switch set in
the OFF position).
(Note) : The control switch block (FK-1770) is used for the repair parts as a jig.
Setting the "Forced Camera Power ON" mode
1) Select page: O, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01 and
press the PAUSE button of the adjustment remote
commander.
CF-085 board (88P)
VC-265 board (PC9/PC9E)
VC-265A board (PC6E)
BJ-002 board (PC9/PC9E)
BJ-002A board (PC6E)
(60P)
DC-IN connector
Exiting the "Forced Camera Power ON" mode
1) Select page: O, address: 01, and set data: 01.
2) Select page: D, address: 10, data: 00, and press the PAUSE
button of the adjustment remote commander.
3) Select page : 0, address: 01, and set data: 00.
Lens-EVF section
Mechanism deck
AC power
AC IN
adaptor
2-8
When exiting the "Forced Camera Power ON" mode,
connect the control switch block (PS-1770) to the
control switch block (FK-1770).
Control switch block
(PS-1770) (8P)
Control switch block (FK-1770)
(A-7096-840-A) (51P)
(Note)
Adjustment remote
commander (RM-95)