Lcd Hinge Assembly; Assembly - Sony DCR-PC4E Service Manual

2-13.ATTACHING HARNESSES OF THE LCD HINGE ASSEMBLY
1
PR-35 board
Blind plate assembly
Harness
(PD-109) (14P)
Harness
(PR-062) (8P) (2P)
3
Harness
(PR-062) (8P) (2P)
5
Install the PO-5 board in
the direction of the arrow.
Two claws

LCD hinge assembly

Blind plate assembly
Screw (M1.7 × 2.5),
5
7
lock ace, p2
Hinge
4
cover (rear)
Claw
Hinge cover (front)
1
LCD hinge assembly
PO-5 board
Hinge cover (rear)
Hinge cover (front)
Screw (M1.7 × 2.5),
lock ace, p2
A
C
B
D
5 KEY-A03
A
6 Gnd
B
7 KEY-A02
C
8 Gnd
D
CN006
LCD hinge assembly
Attach the PR-35 board to the
LCD hinge assembly with the
both-sided adhesive tape.
Hinge cover (rear)
Two claws
2
Hinge cover (front)
Close hinge cover (rear)
3
in the direction of the arrow.
2
Harness
(PR-062) (8P) (2P)
(8P)
Bend one of the two
harnesses at its connector.
4
PO-5 board
Solder at the
two positions.
A
6
Route the harnesses (PR-062) (8P) (2P)
and (PD-109) (14P) through the hole of the
LCD hinge assembly as shown.
Two screws (M1.7 × 2.5),
3
8
lock ace, p2
Blind plate

assembly

LCD hinge
assembly
When attaching the blind plate assembly, route the
2
harnesses through the notch as shown while taking
care so that the harness must not be caught or pinched.
2-12
Harness
(PD-109) (14P)
(14P)
PR-35 board
Solder at the
two positions.
C
B
LCD hinge assembly
Close Blind plate in the
1
direction of the arrow.
Harness (PR-062) (8P) (2P),
Harness (PD-109) (14P)
D