Removing The Access Panel; Removing The Access Panel; Installing The Access Panel - HP ProLiant DL585 Maintenance And Service Manual

Removal and Replacement Procedures

Removing the Access Panel

1. Power down the server. Refer to "Powering Do wn the Server" ea rlier in this chapter.
2. Extend the server from the rack. Refer to "Extending the Server from the Rack" earlier in
this chapter.
3. Unlock the access panel latch (1).
4. Lift up on the latch (2) and remove the access panel (3).
Figure 2-6: Removing the access panel

Installing the Access Panel

1. Place the access panel on top of the server with the latch open. Allow the panel to extend
past the rear of the server approximately 1.25 cm (0.5 in).
2. Push down on the latch. The access panel slides to a closed position.
2-8
WARNING: Pressing the Power On/Standby button sets the server to the standby
position, which removes power from most areas of the server. However, portions of the
power supply and some internal circuitry remain active until the AC power cord is
removed.
WARNING: To reduce the risk of personal injury from hot surfaces, allow the internal
system components to cool before touching.
CAUTION: Electrostatic discharge can damage electronic components. Properly ground
yourself before beginning any installation procedure.
HP ProLiant DL585 Server Maintenance and Service Guide