HP ProLiant DL585 Maintenance And Service Manual page 111

P
part numbers
mechanical components 1-3
system components 1-5
pass-through board, removing 2-35
PCI-X buses, numbering 2-31
PCI-X non-hot-plug, expansion board
removing 2-31
replacing 2-32
PCI-X technology
features 2-30
load balancing 2-30
peak frequency 2-30
performance balancing 2-31
slot population 2-31
POST error messages 5-8
power button/LED assembly, removing and
replacing 2-29
power supply blank, removing and replacing 2-22
power supply, removing and replacing 2-23
powering up, normal sequence 5-2
preparation procedures
overview 2-3
removing server from the rack 2-9
processor memory boards
air baffle 2-12, 2-15
cautions 2-10
installing 2-12, 2-14
locating 2-11
processor power modules (PPMs), when to
replace 5-8
processors See processor memory boards. See
processor memory boards
ProLiant Essentials
diagnosing installation failure 5-9
installation problems 5-9
memory problems 5-9
Q
QuickFind Diagnostic Display
LEDs, location 4-7
LEDs, status 4-7
R
rack
extending the server 2-6
replacing server 2-7
rail release levers
locating 2-7
warning 2-7
RBSU See ROM-Based Setup Utility
rear fan cage, removing and replacing 2-37
HP ProLiant DL585 Server Maintenance and Service Guide
removable media board, removing and
replacing 2-36
removal and replacement procedures
preparation 2-3
removing
access panel 2-8
Battery-Backed Write Cache (BBWC)
assembly 2-38
fans, hot-plug 2-24
front fan cage 2-34
media board 2-36
media drive 2-25
pass-through board 2-35
rear fan cage 2-37
SCSI backplane 2-40
SCSI cables 2-33
server from rack 2-9
Torx T-15 tool 2-5
replacing
fans, hot-plug 2-24
server in rack 2-7
ROM
BIOS problem dignosis 5-9
problem diagnosis 5-9
updates on the Web 2-10
ROM Based Setup Utility, described 3-2
ROMPaq Utility, described 3-2
S
SCSI backplane, removing and replacing 2-40
SCSI cables, removing and replacing 2-33
server
extending from the rack 2-6
mechanical components 1-3
removing from rack 2-9
replacing in rack 2-7
system components 1-5
warnings and cautions 2-2
spare part numbers
mechanical components 1-3
system components 1-5
static electricity, prevention 2-1
switches
iLO/ Redundant ROM Override (SW5) 4-20
internal diagnostic display 4-15
non-maskable interrupt 4-21
rear unit identification 4-22
system board 4-16
system ID (SW4) 4-19
system battery, installing 2-42
system board
iLO/ Redundant ROM Override switch
(SW5) 4-20
removing and replacing 2-43
switches 4-16
Index
Index-3