Operation; Setting Up The Scanner - Polaroid SprintScan SS35 Repair Manual

Slide Scanner Repair Manual

Operation

The following operational flow diagrams (Figures 1-3 through 1-6) briefly describe how to setup
the slide scanners, install and start their software, assign their SCSI ID value, and scan a
mounted or unmounted 35 mm transparency using the SprintScan 35 application software.
Each operational flow diagram is intended to be used only as a Quick reference for the repair
person. For detailed information pertaining to the information in each operational flow diagram
(setting up the slide scanner, installing and starting its software, assigning its SCSI ID and
checking the SCSI connection, and scanning a 35 mm transparency using SprintScan, refer to the
applicable slide scanner User's Guide.
Setting Up the Slide Scanner
Windows Version
Notes: 1 - If host already has a SCSI adapter, add slide scanner to SCSI chain.
2 - If slide scanner is only, or last device, in SCSI chain.
DO NOT CONNECT SS35 ES SLIDE SCANNER TO SCSI CHAINS
WITH HARD DRIVES (Applies to PC, only and slide scanners with
firmware version 1.02 or lower).
Adaptec SCSI
Adapter to Host
Assign /Select
SCSI ID
Connect
Scanner to Host
SS35/SS35 ES
Connect
2
SCSI Terminator
to Scanner
Turn On Scanner,
then Host
Figure 1-3. Setting up slide scanner
Install 1
SS35 PLUS
Turn On
SCSI Terminator
Switch
A
22
Scanner Overview
Mac Version
Set to 6
2