Display Setup; User's Manual 1.02 - SGM Giotto 1500 Instruction Manual

GB
Restoring the default parameters
PREVIOUS=SET
PREVIOUS=OFF
2 Connect Giotto 1500 to the power supply, wait till it has completed reset operations.
Use the DIAL to find the "
3 Use the DIAL to select the menu desired among:
BRIGHTNESS - DISPLAY FLIP
4 Press ENTER to confirm.
Display brightness
BRIGHTNESS=40%
Display reading position
DISPLAY FLIP DISPLAY FLIP
Giotto 1500
This feature allows to reset the values of the parameters which were set
immediately before FACTORY=SET procedure. In other words, if the
default parameters have been set by mistake, this allows to return to the
values previously set.
1. Use the DIAL to find "PREVIOUS" menu
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select the voice "PREVIOUS=SET"
4. Press ESC to restore the values cancelling the operation FACTORY
DEFAULT. In the meantime the voice PREV stops flashing and the
message PREVIOUS=OFF appears.

DISPLAY SETUP

PAN-TILT SETUP
Operators can select one of the brightness levels available for Giotto 1500
display, which can be standard or very low. This option is intended for
theatre and television
troublesome.
To change display brightness:
1. Use the DIAL to find "BRIGHTNESS" menu.
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select the option desired.
4. Press ESC to confirm.
When the fixture is mounted "upside down" on a structure, operators can
turn the display through 180°, thus greatly facilitating the reading of the
menus on the display.
To change the reading position, proceed as follows:
1. Use the DIAL to find "DISPLAY FLIP" menu.
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select the option desired.
4. Press ESC to confirm.
" menu. Press ENTER to confirm.
use, where excessive
- 59 -
SGM
brightness can be

User's Manual 1.02