Connection; Ethernet-Artnet Connection; Firmware Updating; Rs-232 C Onnection - SGM Giotto 1500 Instruction Manual

SGM
2.10 RS-232 Connection
For this connection, use good quality screened coax cable (RG58 50Ohms) to avoid problems with
signal transmission and faulty fixture operation. Connectors must always be 5-pin XLRs.
Refer to the diagram for wiring.

2.11 Ethernet-artnet connection

The device has an ethernet connector to receive the DMX commands with artnet protocol.
As regards the setting of all the artnet parameters see the description in the menu.

2.12 Firmware updating

To update the firmware of the fixture you need:
USB-DMX Driver to install the new hardware.
USB-DMX cable to connect the unit to thel PC .
Updated software version.
Please follow the below procedure to perform the updating:
1. Install the USB-DMX driver on the PC you will use to download the software.
The driver and the instructions to install it will be available in our web site www.sgm.it
2. Connect the USB-DMX cable from the PC to the fixture.
3. Download the software.
The software is composed by an upd file and a file with extention .exe, by opening the file .exe the
updating will be enabled automatically.
This software won't update the microprocessors of the fans boards fitted in the head, of the ballast
and the PFC.
It will be possible to download the software from our web site www.sgm.it.
User's manual 1.02
- 26 -
GB
Giotto 1500