SGM
GB
2.7 Construction of the dmx termination
The termination avoids the risk of DMX 512 signals being reflected back along the cable when they
reaches the end of the line:
under certain conditions and with certain cable lengths, this could cause them to cancel the
original signals.
The termination is prepared by soldering a 120Ohm 1/4 W resistor between pins 2 and 3 of the 5-
pin male XLR connector (see diagram)..
2.8 Wireless DMX
Giotto 1500 has a standard DMX wireless connection. It uses a technology originating from GSM,
with a range of action, which is over 500 metres.
It has widely been tested in places with WiFi signal, Bluetooth, GPRS-UMTS, giving excellent
results.
In case someone wants to use the dmx wireless protocol as an alternative to the cable see the
description in the menu.
- 24 -
User's manual 1.02
Giotto 1500