Micro Computer Control; Icro Omputer Ontrol; Longlife Rechargeable Buffer Battery; Navigazione All Interno Del Menu - SGM Giotto 1500 Instruction Manual

GB
3.1 Microcomputer "Control"
Giotto 1500 is fitted with a microcomputer that enables the best fixture customization to the type
of installation. It is possible:
To assign the starting address
Receive data on lamp elapsed time and fixture operating time
Run diagnostic checks controlling the correct functionning of the fixture
Customization of some of the parameters

3.2 Longlife rechargeable buffer battery

Giotto 1500 Microcomputer is also powered by an internal buffer battery which enables to use the
display functions even by not powered fixture. For powering the dispaly from the battery, press the
enter key for some seconds and the display will switch on automatically.
3.3 Navigazione all'interno del menu
When it's switched on, the fixture runs a start-up reset procedure and the display indicates if
there's an input signal or not.
A DIAL and two keys – ENTER and ESC – set beside the display allow the selection and the use of
the various sub-menu, which compose the main menu.
DIAL: It allows to scroll the different entries, which compose the menu. Inside the selected
menu it allows to modify the wanted parameters.
ENTER key: it allows the access to the selected menu.
ESC key: it allows to come out of the selected menu and, once the necessary changes are
made, it allows to confirm them.
Giotto 1500
3. M
ENTER
DIAL
ESC
ENTER
ESC
- 37 -
C
ICRO OMPUTER
DIAL
User's Manual 1.02
SGM
C
ONTROL