SGM Giotto 1500 Instruction Manual page 55

GB
Setting Pan movement starting angle
PAN POS MIN=000
PAN POS MAX=004
Direction of Tilt movement
TILT MOVE=NORM
Limiting Tilt movement
TILT POS MIN=000
TILT POS MAX=004
Giotto 1500
Giotto 1500 has a Pan movement range of 530°. If the entire excursion
doesn't have to be used, two parameters allow to set the starting angle
(MIN) and ending angle(MAX), which 4°. To limit pan movement, proceed
as follows:
1. Use the DIAL to find the "PAN POS MIN" menu if the starting angle has
to be modified. If the ending angle has to be modified, find the "PAN
POS MAX" menu. It is not necessary to use the max excursion, two
parameters allow to limit the starting angle (Pan Position Min) and the
ending angle (Pan Position Max).
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select the new starting (or ending) angle.
4. Press ESC to confirm.
This function allows to decide the direction in which Giotto 1500 moving
heads tilts, indispensable when several fixtures indispensabile s are
installed in order that fixtures installed opposite each other move in the
same direction when they receive a command.
To modify Pan movement, proceed as follows:
1. Use DIAL to find "TILT MOVE" menu.
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select which of the two available options is required.
4. Press ESC to confirm.
Giotto 1500 a a Tilt movement range of 250°. If the entire excursion
doesn't have to be used, two parameters allow to limit the starting angle
(TILT POS MIN) and the ending angle (TILT POS MAX). The only limiti s the
minimum difference between starting (MIN) and ending(MAX), which is 4°.
To limit the tilt movement procede as follows:
1. Use DIAL to find "TILT POS MIN" menu the starting angle has to be
modified. If the ending angle has to be modified, find the "TILT POS
MAX" menu. It is not necessary to use the max excursion, two
parameters allow to limit the starting angle (Tilt Pos Min) and the
ending angle (Tilt Pos Max).
2. Press ENTER to confirm. The message on the display will start to flash.
3. Use the DIAL to select the new starting (or ending) angle
4. Press ESC to confirm.
- 55 -
SGM
User's Manual 1.02