Dust Collection - Shop fox W1837 Owner's Manual

Model W1837 (For Machines Mfd. Since 1/15)
Dust.Collection
Recommended.CFM.at.Dust.Port:................. 400.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must consider these variables: (1) CFM rating of
the dust collector, (2) hose type and length between the
dust collector and the machine, (3) number of branches
or wyes, and (4) amount of other open lines throughout
the system. Explaining how to calculate these variables
is beyond the scope of this manual. Consult an expert or
purchase a good dust collection "how-to" book.
Tools.Needed.
Dust Collection System ........................................1
Dust Hose 4" .....................................................1
Hose Clamps 4" ..................................................2
To connect a dust collection hose, do these steps:
1. Fit 4" dust hose over dust port, as shown in Figure.
36, and secure it in place with hose clamp.
2. Tug hose to make sure it does not come off.
Note: A tight fit is necessary for proper
performance.
This. machine. creates. substantial.
amounts. of. dust. during. operation..
Breathing. airborne. dust. on. a. regular.
basis. can. result. in. permanent. respira-
tory.illness..Reduce.your.risk.by.wear-
ing.a.respirator.and.capturing.the.dust.
with.a.dust.collection.system.
Qty
Figure.36. Dust port connected to dust
-27-
collection system.