Table of Contents
Advertisement
Model W1811 (For Machines Mfd. Since 6/14)
Dust Collection
Recommended CFM at 4" Dust Port: ............. 400 CFM
Recommended CFM at 2
NOTICE
Do not confuse this CFM recommendation with the
rating of the dust collector. To determine the CFM at
the dust port, you must consider these variables: (1)
CFM rating of the dust collector, (2) hose type and
length between the dust collector and the machine, (3)
number of branches or wyes, and (4) amount of other
open lines throughout the system. Explaining how to
calculate these variables is beyond the scope of this
manual. Consult an expert or purchase a good dust
collection "how-to" book.
1. Secure a 4" dust hose to the dust port located under
the saw table (Figure 42).
Note: For fast and easy connection to a dust collec-
tion system, we recommend using the Model W1038
4" Quick Disconnect fitting, as shown in Figure 42.
2. Attach a 2½" dust hose to the blade guard dust port,
as shown in Figure 43.
3. Run the 2½" hose over the hose support, as shown in
Figure 44.
/
" Dust Port: .......... 150 CFM
1
2
DO NOT operate this machine with-
out an adequate dust collection sys-
tem. This machine creates substantial
amounts of wood dust while operating.
Failure to use a dust collection system
can result in short and long-term respi-
ratory illness.
D3996
4" x 2½"
Y-Fitting
Figure 42. 4" dust port connected.
Figure 43. 2½" Dust port connected.
Figure 44. Dust hose support in use.
-29-
W1038
4" Quick Disconnect
Advertisement
Table of Contents
