Shop fox W1837 Owner's Manual page 25

Model W1837 (For Machines Mfd. Since 1/15)
12.. Insert (2) M8-1.25 x 16 hex bolts into bottom slot on
left end of fence rail (see Figure.22). These will be
used later for mounting the switch.
13. Orient fence rail so scale is facing you. Slide (4)
M8-1.25 x 30 hex bolts into slot on right end of rail
and (4) M8-1.25 x 30 hex bolts into slot on left (see
Figure 23).
14. Install end cap with (2) pre-installed tap screws on
left end of front fence rail (see Figure 24).
15. Align hex bolts in fence rail with holes in table, then
insert bolts into table. Be sure scale on fence rail is
facing up. Hand tighten (8) M8-1.25 hex nuts onto
hex bolts. Do not fully tighten yet (see Figure 25).
Figure.22. Hex bolts for mounting switch.
Slot
Scale
Figure.23. Hex bolt positioned in front
x 2
Figure.24. Left end cap of front fence
Figure.25. Mounting front fence rail.
-23-
x 2
x 8
fence rail slot.
rail.