Table/Dado Insert Adjustment - Shop fox W1837 Owner's Manual

Model W1837 (For Machines Mfd. Since 1/15)
Table/Dado.Insert.
Adjustment
The table/dado insert must sit perfectly flush with the
table to provide a smooth, continuous surface for the
workpiece to slide over. The insert is held in place by a
magnet and sits on top of five adjustment screws (see
Figure.115). The insert should be checked and adjusted
any time it is removed and replaced, after prolonged
use, or any time you notice the workpiece does not slide
smoothly across the insert.
Tools.Needed.
Phillips Head Screwdriver #2 ..................................1
Straight Edge ....................................................1
To.check.and.adjust.insert,.do.these.steps:
1. DISCONNECT MACHINE FROM POWER!
2. Place straightedge across insert and check to make
sure insert is flush with table at front and back of
throat.
— If insert is flush with table, no adjustments are nec-
essary.
— If insert is not flush with table, proceed to Step.3.
3. Insert screwdriver through holes shown in Figure.115
and either loosen screws to raise insert, or tighten
screws to lower it. Repeat Steps 2–3 until insert is
perfectly flush with surface of table.
Qty
Figure.115. Location of table/dado insert
holes with adjustment screws.
-71-