Dust Collection - Shop fox W1770 Owner's Manual

W1770 21" Bandsaw w/Foot Brake
Dust.Collection
Recommended.CFM.at.each.Dust.Port:.......... 400.CFM
Do not confuse this CFM recommendation with the rating
of the dust collector. To determine the CFM at the dust
port, you must take into account many variables, includ-
ing the CFM rating of the dust collector, the length of
hose between the dust collector and the machine, the
amount of branches or Y's, and the amount of other open
lines throughout the system. Explaining this calculation
is beyond the scope of this manual. If you are unsure of
your system, consult an expert or purchase a good dust
collection "how-to" book.
DO. NOT. operate. this. machine. without. an. adequate.
dust.collection.system..This.machine.creates.substan-
tial.amounts.of.wood.dust.while.operating..Failure.to.
use. a. dust. collection. system. can. result. in. short. and.
long-term.respiratory.illness.
To.connect.the.dust.collection.hoses,.do.these.steps:
1. Fit a 4" dust hose over each dust port, as shown in
Figure 22, and secure in place with a hose clamp.
2. Tug each hose to make sure it does not come off.
Note:.A tight fit is necessary for proper perfor-
mance.
Figure.22. Dust hoses connected to dust
-19-
port.