Assembly - Shop fox W1837 Owner's Manual

Assembly

Before beginning, refer to the Items.Needed.for.Setup
section and gather all applicable items.
To.assemble.table.saw,.do.these.steps:
1.. With help from another person, lift table saw unit
off of shipping pallet and onto floor.
2. Install each of the two caster support brackets onto
right front and rear stand legs using (2) M8-1.25 X
16 button head cap screws, (2) 8mm flat washers,
(2) 8mm lock washers, and (2) M8-1.25 hex nuts (see
Figure.12).
3. Install casters onto caster support brackets and
mounting bracket using (3) M8-1.25 X 65 hex bolts
and (3) M8-1.25 lock nuts (see Figure.13).
4. Install caster foot levers onto support brackets and
mounting bracket, each using (1) M8-1.25 X 65 hex
bolt, (2) spacers, and (1) M8-1.25 lock nut (see
Figure.14).
Model W1837 (For Machines Mfd. Since 1/15)
Figure.12. Caster support brackets
installed on stand legs.
x 3
Figure.13. Caster installed onto mounting
x 1
Spacer
Figure.14. Caster foot lever (1 of 3)
installed on front right support bracket.
-20-
x 2
Caster
Support
Brackets
Mounting
Bracket
bracket.
Caster Foot
Lever
Spacer