Shop fox W1837 Owner's Manual page 24

9. Place straightedge across extension wings and main
table to ensure combined table surface is flat.
— If combined table surface is flat, skip to next step.
— If outside end of extension wing tilts down, remove
wing and place a strip of masking tape along bot-
tom edge of main table to shim end of wing up (see
Figure.18).
— If outside end of extension wing tilts up, remove
wing and place a strip of masking tape along top
edge of main table to shim end of extension wing
down (see Figure 19).
Note:.After re-installing wings, remove all excess
masking tape with a razor blade.
10. Insert two connecting bars into long section of front
fence rail and tighten set screws, then slide short
section of rail onto connecting bars and tighten set
screws (see Figure 20).
11. Insert connecting bar into long section of rear fence
rail and tighten set screws, then slide short section
of rail onto connecting bar and tighten set screws
(see Figure 21).
Model W1837 (For Machines Mfd. Since 1/15)
Figure.18. Masking tape location for tilting
the extension wing up.
Figure.19..Masking tape location for tilting
the extension wing down.
Short Section
Connecting Bars
Figure.20. Front fence rail assembled.
Long Section
Connecting Bar
Figure.21. Rear fence rail assembled.
-22-
Long
Set Screw
Section
Set Screw Short
Section