Shop fox W1837 Owner's Manual page 26

16. Install switch onto hex bolts from Step.12 using (2)
M8-1.25 hex nuts and (2) 8mm lock washers (see
Figure 26).
17. Secure rear fence rail to backside of table using (4)
M8-1.25 x 20 cap screws, then secure rear fence rail
to extension wings with (4) M8-1.25 x 20 cap screws
and (4) M8-1.25 hex nuts. Be sure lip of fence rail
faces up and away from table, as shown in Figure
27.
18. Install saw blade as instructed in Blade.Installation.
on Page 34.
19. Install table insert in table opening (see Figure 28).
Check to make sure it is flush and adjust if necessary
(see Table/Dado.Insert.Adjustment.on Page.71.for
more information).
Model W1837 (For Machines Mfd. Since 1/15)
Figure.26. Switch installed.
x 4
Lip
Figure.27. Mounting rear fence rail.
Figure.28. Standard table insert installed.
-24-
x 2
x 4