Datcom; Usb - Fronius Primo 3.0-1 Operating Instructions Manual

DATCOM

Checking data communications, entering the inverter number, DATCOM night mode, pro-
tocol settings
Setting range
Status
Indicates data communication is taking place via a Fronius Solar Net or that a data com-
munications error has occurred
Inverter number
Sets the number (= address) of the inverter in a system with several solar inverters
Setting range
Factory setting
IMPORTANT! If a number of inverters are linked together in a data communications sys-
tem, assign a unique address to each one.
Protocol type
Specifies the communications protocol to be used to transfer the data:
Setting range
Factory setting
* The protocol type 'interface protocol' only functions when there is no Datamanager card
in the inverter. All Datamanager cards must be removed from the inverter.

USB

Specification of values in conjunction with a USB stick
Setting range
Safely remove hardware
To remove a USB stick from the USB A socket on the plug-in data communications card
without losing any data.
The USB stick can be removed:
-
-
Software Update
To update the inverter software via a USB stick.
28
***
WiFi Access Point
[not available]
Displayed if there is no system monitoring present on the invert-
er.
Status / inverter number / protocol type
00 - 99 (00 = 100th inverter)
01
Fronius Solar Net / interface protocol *
Fronius Solar Net
Safely remove hardware / Software update / Logging interval
when the OK message appears
when the 'Data transfer' LED stops flashing or comes on steady