Fan - Fronius Primo 3.0-1 Operating Instructions Manual

Meter calibration
Input of a correction value to ensure that the value shown on the inverter display corre-
sponds with the calibrated display on the electricity meter
Unit
Setting range
Factory setting
Currency
Set the currency
Setting range
Feed-in tariff
Set the remuneration rate for energy fed into the grid
Setting range
Factory setting

Fan

To check that the fan is working correctly
Setting range
-
-
-
34
%
-5.0 - +5.0
0
3 characters, A-Z
2 digits, 3 decimal places
(depends on country setup)
Test fan #1 / Test fan #2 (depending on the device)
Use the 'Up' and 'Down' keys to select the desired fan
Testing of the selected fan is initiated by clicking 'Enter'.
The fan will continue to run until the operator exits the menu by pressing 'Esc'.