Energy Yield - Fronius Primo 3.0-1 Operating Instructions Manual

Contrast
Set the contrast on the display
Setting range
Factory setting
Since the contrast is temperature-dependent, when the ambient conditions change it may
be necessary to adjust the 'Contrast' menu item.
Illumination
Initial setting for display illumination
The 'Illumination' menu item only relates to the display backlighting.
Setting range
Factory setting

Energy yield

Setting
-
-
-
-
Setting range
Meter deviation
Input of a value for the fed-in energy that will be added to the energy currently fed in (e.g.
carry-over value when replacing an inverter)
Unit
Setting range
Factory setting
ON: DATCOM mode is always in effect. The inverter supplies 12 V continuously
to power the Fronius Solar Net. The display is always active.
IMPORTANT! If DATCOM night mode is set to ON or AUTO when there are
Fronius Solar Net components connected, then the inverter's current con-
sumption during the night will increase to around 7 W.
OFF: DATCOM will not run at night, the inverter will not need any AC current in
order to supply power to the Fronius Solar Net.
The display is switched off during the night and the Fronius Datamanager is
not available.
0 - 10
5
AUTO / ON / OFF
AUTO
AUTO: Display backlighting is activated by pressing any key. If no key is pressed for
2 minutes, the display backlighting will go off again.
ON: The display backlighting remains permanently on when the inverter is
switched on.
OFF: The display backlighting is permanently switched off.
of an OFFSET value for the total energy display
of a measuring offset factor for the day, year and total energy display
of the currency
of the feed-in tariff
Meter deviation / Meter calibration / Currency / Feed-in tariff
Wh / kWh / MWh
Five digits
0
33