IBM eServer 342 xSeries User Reference Manual page 114

Code Function
202 System cache
206 Diskette drive
215 CD-ROM
217 Hard disk drive
Table 14. Diagnostic error messages.
100
IBM xSeries 342: User's Reference
Result Text message
Aborted Test setup error: BIOS cannot access
VPD information
Test setup error: Corrupt DMI BIOS.
Information in BIOS is not as
expected
Test setup error: No L2 cache
detected on microprocessor socket id
xyz or BIOS setup problem
(where xyz identifies the
microprocessor that is causing the
error message)
Test setup error: Unknown hardware
problem associated with
microprocessor in socket id xyz.
(where xyz identifies the
microprocessor that is causing the
error message)
Failed Microprocessor in socket ID xyz
(where xyz identifies the
microprocessor that is causing the
error message)
Note: The indicated microprocessor
LED will be on.
Warning Test setup error: Cache is disabled.
Use system setup to enable before
retrying the test
Failed Internal diskette drive bay
Aborted The CD-ROM drive is not present.
Failed On system board.
Failed BIOS drive # n (where n is the drive
bay number)
Action
If your server does not have the
latest level BIOS code installed,
update the BIOS code to the
latest level and run the
diagnostic program again.
If the problem persists, call for
service.
1. If your server does not have
the latest level BIOS code
installed, update the BIOS
code to the latest level.
2. Run the diagnostic program
again.
3. If the problem remains,
replace the failing
processor.
If the problem persists, call for
service.
1. Reseat the identified
microprocessor.
2. If the problem remains,
replace the microprocessor.
If the problem persists, call for
service.
Use the Cache Control choice
from the Advanced Setup menu
to enable the cache.
If the problem persists, call for
service.
Call for service.
Verify that the cables are
properly connected to the CD-
ROM drive.
If the problem persists, call for
service.
Call for service.
Call for service.