Table of Contents
Advertisement
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
How to lift the entire vehicle:
1.
Install the wheel chocks in front and behind each front wheel.
2.
Put the jack below the center of the rear frame crossmember.
3.
Lift the vehicle enough to put jack stands below the outer ends of the rear axle as shown.
4.
Lower the jack and test the stability of the vehicle on the two jack stands.
5.
Put the jack at the center of the front axle.
6.
Lift the vehicle enough to put two jack stands below the front frame crossmember as shown.
7.
Lower the jack and test the stability of the vehicle on all four jack stands.
How to lift the rear of the vehicle only:
1.
Put the wheel chocks in front and
behind each front wheel.
2.
Put the jack below the center of the rear
frame crossmember.
3.
Lift the vehicle enough to put a jack
stand below the outer ends of the rear
axle as shown.
4.
Lower the jack and test the stability of
the vehicle on the two jack stands.
How to lift the front of the vehicle only:
1.
Put the wheel chocks in front and
behind each rear wheel.
2.
Put the jack at the center of the front
axle.
3.
Lift the vehicle enough to put two jack stands below the front frame crossmember as shown.
4.
Lower the jack and test the stability of the vehicle on the two jack stands.
Lower the vehicle:
1.
Lift the vehicle enough to remove the jack stands.
2.
Carefully lower the vehicle to the ground with the jack.
Flat Portion
of Frame
Outside End
of Rear Axle
View from Underside of Vehicle
Owner's Guide
MAINTENANCE
Center of
Front Axle
B
43
Advertisement
Table of Contents
