Table of Contents
Advertisement
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.
Passenger side countertop must be removed and module clamp must be loosened before attempting module
2.
12" and 18" Center Module: Both the 12"
and 18" modules are positioned by four dim-
ples on the bottom. Removal of the larger
units may require a second person to help
support the module. To slide the module out,
a slight upward force must be applied along
with a pulling force to nudge dimples free.
Once module is loose, support with both
hands.
Passenger side countertop must be removed and module clamps must be loosened before attempting module
3.
6" Pull Out Module: All 6" modules are the
same size and similar weight. They have
alignment dimples on the bottom for posi-
tioning. To remove these modules, remove
the passenger side counter top and loosen
both module clamps (refer to lock down
mechanism) and gently pull the module up
and out using the door handle and or top end
of module.
OPERATING PROCEDURES
removal.
removal.
Owner's Guide
Positioning Dimples
(all four corners)
The 12" module shown.
18" module has wider
spacing and shelving.
6" pull out module
housing
Make sure pull board is inside
the module with the door
closed before removing module.
Positioning dimples
located on bottom
B
29
Advertisement
Table of Contents
