Emissions Labels And Engine Access - Cushman Refresher fs2 Owner's Manual

OPERATING PROCEDURES
Read all of SAFETY and this section before attempting any procedure. Pay particular attention to Notices, Cautions, Warnings and Dangers.

Emissions Labels and Engine Access

B
REFRESHER FS2
Remove the side drawer from its position to view the engine
compartment.
1. Remove the two screws from underneath the front of the
drawer.
2. There are tabs in the rear that help hold the drawer
frame in place. Lift up on the front of the drawer and
gently pull the drawer out to disengage the tabs. It may
be necessary to work the drawer up and down slightly
while pulling gently to release from the tabs.
The emission labels are visible once the engine compart-
ment is accessed.
Install the drawer:
1. Slide the drawer straight back into the opening.
2. Lightly push down on the front of the drawer to lift the
rear up slightly, while continuing to slide the drawer in. It
may be necessary to work the drawer up and down slightly to lock the drawer into place correctly.
3. When installed, push down on the front of the drawer to verify correct fit. The rear of the drawer should not move.
4. Install the screws.
REFRESHER NSF and OASIS
The emissions label for these models is under the seat. Lift the seat for access.
26
REFRESHER FS2
Owner's Guide