Installation; Mounting The Outboard Motor On Boat - TOHATSU M 9.9 Owner's Manual

16

INSTALLATION

1. Mounting the outboard motor on boat

�������
!
Most boats are rated and certified
in terms of their maximum allowable
horsepower, as shown on the boat's
certification plate. Do not equip your boat
with an outboard motor that exceeds this
limit. If in doubt, contact your dealer.
3
Do not operate the outboard motor until it
has been securely mounted on the boat in
accordance with the instructions below.
Installation
■ Single-engine Installation
Set engine at center of boat.
Center of Boat
■
Twin-engine Installation
W h e n i n s t a l l i n g t w o o u t b o a r d
engines, be sure to keep an interval
of approximately 580 mm (22.8 in)
between the two.
Approx.580 mm (22.8 in)
Transom matching
1 Be sure that the anti ventilation plate
2 To attach the outboard motor to the
Boat Transom
A rope is not included in the standard
accessories.
Washer
of the outboard motor is 30-50mm
(1.2-2 in) below the bottom of hull.
If the above condition cannot be
met due to the shape of the bottom
of your boat, please consult your
authorized dealer.
Bottom of hull
Anti Ventilation Plate
boat, tighten the clamp screws by
turning their handles.
A l s o , u s e t h e b o l t s t o s e c u r e
the outboard motor brackets on
transom board.
Secure the outboard motor with a
rope to prevent loss overboard.
Note
Clamp
screw
Nut &
Bolt
Washer
30-50 mm
(1.2-2 in)
*option