Bypass Tray - Toshiba e-studio 167 Service Manual

10.4.2

Bypass tray

[A] Operation of drawer pickup roller
When the paper is set on the bypass tray, the bypass sensor (S8) detects it and judges that there is
paper on the bypass tray, and the bypass feeding is performed in preference to drawer feeding.
When the bypass pickup solenoid (SOL1) is turned ON, the driving force of the main motor (M3) is
transmitted to the bypass pickup clutch and bypass feed clutch. The bypass pickup roller is shifted
down by the drive from the bypass pickup clutch. And then, the bypass pickup roller, as well as the
bypass feed roller, is rotated by the drive from the bypass feed clutch to transport the paper on the
bypass tray to the bypass feed roller.
Bypass feed clutch
Bypass pickup clutch
Bypass feed clutch
Bypass feed roller
Bypass pickup clutch
Bypass separation pad
Bypass pickup solenoid
10
Bypass pickup roller
Fig. 10-4
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO167/207/237
PAPER FEEDING SYSTEM
10 - 7