Disassembly And Replacement - Toshiba e-studio 167 Service Manual

13.6 Disassembly and Replacement

[A] Fuser / Exit unit
(1) Take off the right rear cover.
P.2-22 "[I] Right rear cover"
(2) Lay down the transfer unit.
(3) Disconnect 3 connectors, remove 2 screws,
and then take off the fuser/paper exit unit.
Note:
Be careful because the fuser/paper exit unit
is hot.
[B] Pressure roller unit / Fuser roller unit
(1) Take off the fuser/paper exit unit.
P.13-12 "[A] Fuser / Exit unit"
(2) Remove 1 spring and 2 screws.
(3) Separate the pressure roller unit from the
fuser roller unit.
Note:
If the ADU (optional) is installed, the spring
has already been removed.
Note:
Separate the pressure roller and the heat
roller while pressing the thermistor ground
leaf spring.
e-STUDIO167/207/237
FUSER / EXIT UNIT
Fuser/ Paper exit unit
Fuser roller unit
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
13 - 12
Connector
Screw
Stepped screw
Fig. 13-6
Spring
Pressure roller unit
Fig. 13-7
Thermistor ground leaf spring
Fig. 13-8