Toshiba e-studio 167 Service Manual page 118

(3) Take off the CIS case.
Notes:
1. When installing the CIS case, be sure to
fit the shaft of the equipment in the shaft
guide attached on the bottom of the CIS
case.
2. When installing the CIS case, install it so
that the "L" shaped portion of the bottom
of the CIS case comes under the CIS unit
drive belt-1.
[I] CIS unit drive belt-1
(1) Take off the CIS case.
P.6-25 "[H] CIS case"
(2) Loosen 1 fixing screw of the tension bracket.
e-STUDIO167/207/237
SCANNER
Tension bracket
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
6 - 26
CIS case
Fig. 6-35
L shaped potion
Shaft guide
Shaft
Fig. 6-36
Fig. 6-37