Toshiba e-studio 167 Service Manual page 169

[Q] Registration roller (metal)
(1) Take off the Process unit.
P.11-9 "[A] Process unit"
(2) Take off the transfer unit.
P.11-17 "[N] Transfer unit"
(3) Take off the registration roller clutch.
P.10-21 "[M] Registration roller clutch
(CLT1)"
(4) Remove 1 clip, 1 bushing and then take off
the registration roller (metal) while sliding it to
the rear side.
(5) Remove 1 bushing, 1 E-ring and then take
off 1 gear and 1 pin.
[R] Feed gear unit
(1) Take off the main motor drive unit.
P.9-7 "[C] Main motor drive unit"
(2) Take off the registration roller clutch.
P.10-21 "[M] Registration roller clutch
(CLT1)"
(3) Take off the pickup solenoid bracket.
P.10-22 "[N] Pickup solenoid (SOL1)"
(4) Remove 2 screws, and then take off the feed
gear unit.
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 10-47
Registration roller (metal)
Fig. 10-48
Feed gear unit
Fig. 10-49
10 - 25
Clip
Bushing
Registration roller (metal)
E-ring
Gear
Bushing
Pin
e-STUDIO167/207/237
PAPER FEEDING SYSTEM
10