Toshiba e-studio 167 Service Manual page 115

[G] CIS unit (CIS)
(1) Take off the original glass.
P.6-17 "[A] Original glass"
(2) Move the CIS unit to the right most position.
Notes:
• Be sure to hold the CIS unit drive belt-1 to
move the CIS unit.
• When the CIS unit is moved, be sure not
to touch the shaft as the silicon oil is
applied on it.
(3) Remove the seal which fixes the harness.
Note:
Attach the seal by following the procedure
below.
- Place the flat harness along the edge
of the scanner base.
- Align the seal with the two edges of
the scanner base.
© 2007 - 2008 TOSHIBA TEC CORPORATION All rights reserved
Fig. 6-27
Fig. 6-28
Seal
Harness
Fig. 6-29
6 - 23
CIS unit
CIS unit drive belt-1
e-STUDIO167/207/237
SCANNER
6