Connecting To A Lan With Static Ip Addresses; Entering Static Ip Address Parameters From A Telephone Keypad - Net2Phone MAX 4 User Manual

2.2 Connecting to a LAN with Static IP Addresses

This section explains how to connect your Web browser to the Net2Phone MAX 4 if your LAN uses
static IP addresses, using either a telephone keypad or serial connection. The process will entail the
following steps:
1. Disable DHCP in the MAX 4.
2. Enter a static IP address.
3. Enter a net mask address.
4. Reset the MAX 4.
5. Log in to the MAX Web Manager.
6. Set the required configuration parameters in the MAX Web Manager.
2.2.1

Entering static IP address parameters from a telephone keypad

If your LAN uses static IP addresses, the most practical way to set up the MAX 4 is to enter an IP
address and a net mask address from a telephone keypad. You can then finish setting up the unit
while browsing the MAX Web Manager.
2.2.1.1 Disabling DHCP in the Net2Phone MAX 4
Since the Net2Phone MAX 4 is shipped with DHCP enabled, you need to disable DHCP to use
static IP addresses. To disable DHCP, proceed as follows:
1. Connect an analog telephone to any RJ-11 port on the MAX 4.
2. Lift the handset and dial ***5 (the disable DHCP parameter code). The voice prompt
announces, " DHCP is disabled now. Please press pound" .
3. Press the pound key (#) (Important!).
4. Hang up the telephone.
Page 9