Programming - urmet domus 1138/18 Manual

RINGING TONES
The doorphone is provided with an outward-facing call tone signaling
speaker.
The speaker produces four distinctive ringing tones to identify different
types of call:
• Call from main entrance modules. Continuous two-tone ringing for
the duration programmed at the calling module.
• Call from secondary entrance module. Intermittent two-tone ringing
for the duration programmed at the calling module.
• Call from switchboard stations or special doorphones. Series of
three two-tone pulses followed by a pause and repeated for the time
programmed at the calling device.
• Call from landing. Continuous two-tone ringing for the period that the
associated doorbell pushbutton is actuated, with a maximum limit of
5 seconds.
The doorphone with single-port decoder will disable all ringer functions
in the following cases:
• Short circuit in additional doorphone wiring.
• Supply voltage too low.
• Supply voltage too high.
Ringer functions will return to normal when the problem ceases.
Ringing stops when the handset is picked up.
RINGER vOLUME ADJUSTMENT
0V
U I
NOTE: after adjusting volume, store the jumper in the seat provided
on doorphone top casing.
CALLING GUARD DOOR SWITCHBOARD STATION
OR SPECIAL DOORPHONES
Keys T1 and T2 can be programmed to call the guard door switchboard
station or a special doorphone special doorphone (see the paragraph
headed 'Programming').
When the key is pressed, the doorphone will emit a courtesy tone to
indicate that the call has been sent. If the called device is busy and
queues the call in memory, a second courtesy tone will be emitted after
10 seconds.
24
−−−− sec.5a
DOORPHONE WITH SINGLE-PORT DECODER Ref. 38/3
MIN MAX
or
0V

PROGRAMMING

CALLS FROM LANDING
vIDEO MODULE
Doorphone with single-port decoder is designed to control video
module Ref. 1732/1 with associated wall bracket Ref. 1732/92.
This feature makes it possible to activate the video module when a
call is made, and to deactivate it when the call ends. If the call is
not answered, the video signal will continue for a maximum of 30
seconds.
SELF-ACTIvATION FUNCTION
The self-activation function enables the apartment station to display
the image recorded by the cameras installed in the system (generally
for surveillance and monitoring purposes) and to establish a voice
connection with no need for dedicated wiring.
Keys T1 and T2 can be programmed for this function.
The entrance module can be activated in this way only when in
stand-by condition.
MUTE KEY/ DOOR OPEN LED KIT
The doorphone incorporates provision for installing Mute key/Door
Open LED kit Ref. 1038/52. Additional key T2 must be removed o
move in order to install the kit.
U I
PROGRAMMING
DOORPHONE PROGRAMMING METHODS
Doorphone with single-port decoder can be programmed in three
ways:
• At the workshop, using programming terminal Ref. 1038/56 or any
calling device and a power supply unit.
• Directly on the system (which need not be supplied with power)
by connecting programming terminal Ref. 1038/56 directly to the
programming connector.
• On the system supplied with power, using any calling device. This
operation must be carried out by two people who communicate using
transceivers or cellular phones. One person will use the doorphone
system calling device while the other works at the doorphone and
decoder.
CP
OV
DIGIVOICE - Technical Manual