Focus Test Mode - Saeco Syntia Service Manual

SYNTIA

5.1.2 Focus test mode

pos.
lev.
symbol
knob
L1
pos.
lev.
knob
L2
Saeco International Group
MEMO MEMO
2
1
button
press
status
MEMO
MEMO
PRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UP
symbol button
MEMO
Remove water
tank
Open service
hatch
Remove dregs
drawer
Remove the brew
group
MEMO
MEMO
PRESS THE ON/OFF KEY TO ACCESS THE NEXT LEVEL UP
To enter Test Mode
1. position the control knob in the hot water position
2. keep the espresso coffee key pressed
3. turn on the machine by pressing the 0/I button on the
rear (espresso coffee and long coffee blink alternatively)
4. release the espresso coffee button (you go directly to the
1st level of the Test Mode)
To go to a higher level, press the On/Off button
3
Initial LED status at level 1
If the screen does not change from the initial status,
replace the interface card and/or the JP21 flat cable.
If the LED
capacitive sensor and the JP22, JP23 wiring
If the LED
hatch microswitch and the JP16 wiring
If the LEDS
microswitch and the JP16 wiring
If the LED
group microswitch and the JP14 wiring
If the LEDS
the knob card and the JP21 wiring
MEMO
If the LED
knob card and the JP21 wiring
Rev.01 February 2010
05 SERVICE MODE
function
function
Initial LED status at level 2
does not turn on, check the
does not turn on, check the
do not turn on, check the
does not turn on, check the
do not turn on, check
does not turn on, check the
Page 5 / 07